fully automated cnc machines manufacturers remind that in order to ensure the normal operation and use of fully automated cnc machines, certain conditions must be met, including installation position, ambient temperature, and power requirements.

First, installation position

The position of fully automated cnc machines should be far away from the vibration source, should avoid the influence of direct sunlight and thermal radiation, and avoid the influence of moisture and airflow. If there is a vibration source near the machine tool, the vibration groove should be set around the machine tool, otherwise it will directly affect the machining accuracy and stability of the machine tool, so that the electronic components have poor contact and failure, affecting the reliability of the CNC machine tool. fully automated cnc machines

2. Ambient temperature

The ambient temperature of fully automated cnc machines should be less than 30 degrees, and the relative temperature should be less than 80%. In general, the CNC electric control box is equipped with an exhaust fan or cooling fan to keep the electronic components, especially the central processor, at a constant operating temperature or a small temperature difference. Excessive temperature and humidity can reduce the life of control system components and lead to more failures. With the increase of temperature and humidity, dust will increase in the integrated circuit board to produce bonding and lead to short circuit.

Third, power requirements

Generally, fully automated cnc machines installed in the machining workshop not only have large temperature changes, poor use conditions, but also a wide variety of mechanical and electrical equipment, resulting in large fluctuations in the power grid, so the installation of fully automated cnc machines has strict control over the power supply voltage. The fluctuation of the power supply voltage must be within the allowable range and remain relatively stable, otherwise it will affect the normal operation of the numerical control system.

In addition to the above factors, the normal operation of fully automated cnc machines must be in strict accordance with the manual operation, such as the user is using the machine tool, is not allowed to change the control system parameters in the factory Settings, can not replace the machine tool accessories, the use of hydraulic chuck, hydraulic head and tail seat, hydraulic cylinder pressure, No increase shall be allowed within the allowable stress range.

fully automated cnc machines https://www.zjshuangzheng.com/Automatic-CNC-Machine-ES36.html